JVCC FELT-06 Polyester Felt Tape: 3/4 in. x 15 ft. (1mm thickness, Black)

Description

Product Highlights
JVCC FELT-06 Polyester Felt Tape, 1 millimeter thick, is synthetic needle punched felt made from polyester fibers. On one side, it is felt; on the other side, adhesive.
This tape is most frequently used to join and temporarily repair curtains, fabric and cloth drapes used in backdrops and for other general use vibration dampening. There are many other kinds of uses as well.
Tape rolls are typically cut to standard tape industry metric-cut sizes - or approx 5% narrower than the nominal size (i.e. 24mm per 1-inch of nominal width ordered).
Adhesive: synthetic rubber. Carrier/Backing: polyester needled felt. Release Liner: paper (reverse wound). Thickness: 49 mils (carrier, adhesive, liner) 39 mils (carrier, adhesive) 10 mils (liner). Adhesion: 130 ounces per inch (to stainless steel test panel)
Tensile Strength: 23 pounds per inch (longitudinal) 21 pounds per inch (transverse). Service/Operating Temperature: -30°F to 150°F. Application Temperature: 60°F (minimum). Standards Met: meets RoHS Directive 2011/65/EU. Core: 3 inch diameter
JVCC FELT-06 Polyester Felt Tape
is a 1mm thick synthetic needle punched felt made from polyester fibers. One side is felt, and the other side has adhesive. Commonly used for joining and temporarily repairing fabric, curtains and cloth drapes in backdrops and for other general use vibration dampening. Felt material is also used for filtration applications, gaskets, wipers, and padding in a wide variety of industries. JVCC FELT-06 hides seams being photographed, and is used for applying a clean, dark edge to platforms, flats and portals. Can also be used to create matte borders or edges and to line display and jewelry cases. Great for padding furniture on dark stained wood floors to prevent scratches.
Application Instructions
On many of the adhesive felt products the rolls will have an approximately 2 inch to 4 inch leader of double-sided film tape applied to the release liner at the start of the roll. We recommend you either cut a small piece of felt off at the beginning of the roll with a pair of scissors to start, or peel the double-sided film tape off of the release liner to use as a way to begin applying the felt (try not to pull the double-sided film tape off of the felt backing though). It is sometimes easier to try to peel the corner of the felt away from the release liner (instead of the release liner away from the felt) since you may end up splitting the release liner when you do it that way. Made in the U.S.
NOTES: As with any adhesive tape product it is always the user's responsibility to determine that the product is suitable for their intended use; e.g. if you want to remove a product cleanly from a specific type of substrate please test on an inconspicuous area first.
Technical Information
- Core: 3 inch diameter
- Backing/Carrier: non-woven polyester needled felt
- Adhesive: synthetic rubber
- Release Liner: paper (reverse wound)
- Standards Met: meets RoHS Directive 2011/65/EU
- Thickness: 49 mils (carrier, adhesive, liner) 39 mils (carrier, adhesive) 10 mils (liner)
- Adhesion: 130 ounces per inch (to stainless steel test panel)
- Tensile Strength: 23 pounds per inch (longitudinal) 21 pounds per inch (transverse)
- Application Temperature: 60F (minimum)
- Service/Operating Temperature: -30F to 150F